Repair Parts -- new and used -- moderated newsgroup for trading > Hand Tools
> Pliers
> Round nose pliers
> Kestrel 4200 hvac pocket air flow meter cfm anemometer
Kestrel 4200 hvac pocket air flow meter cfm anemometer
For Sale: Kestrel 4200 hvac pocket air flow meter cfm anemometer
Subject Kestrel 4200 hvac pocket air flow meter cfm anemometer
Ad is submitted by poster:
Kestrel 4200 HVAC Pocket Air Flow Meter w CFM Anemometer
See all of our Kestrel offerings
Kestrel instruments are individually tested, calibrated and certified at the factory. The Kestrel 4200 handheld gives quick access to all the features you may need on the job site. HVAC pocket flow meter with CFM measurement and 480 lines of memory.
Humidity Ratio (grains) in gpp, g/kg
Air flow in cfm, L/s, m?/s, m?/m, m?/h
Air Velocity in ft/m, mph, m/s, km/h, kts, Beaufort
Additional measurements of dewpoint, wind chill and heat stress index
Data Logger (automatic and manual)
Minimum, Maximum and Average values
Impeller can be replaced without tools
Humidity sensor can be recalibrated in the field with our Relative Humidity Calibration Kit.
Graphical Display for logged values
Upload to a computer (with optional interface)
Backlight for low light conditions
Includes neck and wrist lanyards, protective pouch and 2 AAA batteries
<2% after 100 hours use at 7m/s
<2% after 100 hours use at 7m/s
Approximately 1 minute for most conditions
Approximately 1 minute for most conditions
±2% over 24 months (can be field calibrated)
Normal operation from -4 to 140°F [-20 to 60°C]. Below -4°F [-20°C],
accurate readings may be taken by keeping the unit warmer than
-4°F [ -20°C] and exposing it for the minimum time necessary to take
a reading (less than 1 minute).
-22°F to 140°F [-30°C to 60°C].
After 15 minutes of no button presses. (This feature can be disabled.)
Two AAA alkaline batteries (included). Typical life, 400 hours
1in. [25 mm.] diameter, sapphire bearings, light weight.
User-replaceable impeller/housing assembly
Hermetically sealed precision thermistor.
Solid state silicon capacitive sensor
5" x 1.8" x 1.1" [12.7 x 4.5 x 2.8 cm.]
-All Sales are Final (See return policy at bottom of this listing)
-Personal checks held 5-14 days .
-Returned checks will incur a $30.00 fee.
*Warranty and Return Information
repair--parts.com bears NO responsibility for this ad. Please report ads that do not follow our
rules (on front page).
Posted By: Fernando Best
Contact: Fernando_best@repair--parts.com (Fernando Best) (this is a temporary forwarding address).
