Repair Parts -- new and used -- moderated newsgroup for trading > Repair Electronics
> Phase Convertors
> New long ranger dust collector multigate system 220V
New long ranger dust collector multigate system 220V
For Sale: New long ranger dust collector multigate system 220V
Subject New long ranger dust collector multigate system 220V
Ad is submitted by poster:
PSI Woodworking 220 Volt Starter Kit
Long Ranger Multigate Switch System
Very Nice System that turns your dust collector on and off with your
dust collector blast gates or switches that you install anywhere in your shop.
Simple and safe low voltage wiring can easily be run anywhere in shop.
Turning your dust collector on and off is automatic when your dust collector is wired to your blast gates.
* Turn on your dust collector when you open a blast gate
* Turn off your dust collector when you close the blast gate
* Simple low voltage wiring and easy installation
This Long Ranger™ system includes a special relay box that your dust collector plugs into. The relay has terminals that you wire to the micro switches on the blast gates. The system is wired in parallel so opening a blast gate turns on your collector, but the dust collector won’t turn off unless all of the gates in your shop are closed. Manual switches can be easily wired into the system so you can manually turn your dust collector on and off from anywhere in your shop.
This set includes a 220V Relay switch box, a switch enabled blast gate and 100 ft of hookup wire.
repair--parts.com bears NO responsibility for this ad. Please report ads that do not follow our
rules (on front page).
Posted By: Cassandra Hobbs
Contact: c-hobbs@repair--parts.com (Cassandra Hobbs) (this is a temporary forwarding address).
