Repair Parts -- new and used -- moderated newsgroup for trading > Hand Tools
> Techron crown 7560 power amplifier turns on
Techron crown 7560 power amplifier turns on
For Sale: Techron crown 7560 power amplifier turns on
Subject Techron crown 7560 power amplifier turns on
Ad is submitted by poster:
TURN ON AND NO FURTHER TESTING DONE
This amplifier is for industrial use and for music also
These power amplifiers supply a controlled voltage (7560/7570) or controlled current (7570) output. In controlled voltage (CV) mode, the output is an amplified voltage representation of the input voltage signal. In controlled current (CC) mode, the output is an amplified current representation of the input voltage signal. If the load's impedance changes, the amplifier seeks to maintain the desired voltage (in CV) or current (in CC).
> Maximum output of 1,018 W rms into a 4 ohm load.
> AC input 120 V standard (47-63 Hz). Internal selection of 100, 200, 220, or 240 V.
> The 7570 has selectable controlled current or controlled voltage modes.
> Connecting two amplifiers in series for push-pull operation approximately doubles available output voltage.
> Stand-alone or rack-mounted operation.
> Protection circuitry prevents damage due to high line voltage, overtemperature, RF burnouts, input overlaid, excessive output
demand, mismatched loads, shorted loads, and internal malfunction.
repair--parts.com bears NO responsibility for this ad. Please report ads that do not follow our
rules (on front page).
Posted By: Raymond Cummings
Contact: email@example.com (Raymond Cummings) (this is a temporary forwarding address).